K
KennethW
- Reaction score
- 3
- Thunderbird Year
- none
Programming the Homelink buttons to run the garage doors. First attempt ended with one button running two doors. Figured I was perhaps too quick to move from one door to the next and the "learn" mode was still active for two doors. Cleared the programming as recommended in the manual and started over. After some fussing around I had 1 door per button working.
After a week or two, the left most button (which is the garage I keep the car in) started opening two doors (programmed to left & center button) again.
Anyone else experienced this?
Could it be a mechanical issue where the left button is actually catching both microswitches?
Didn't see any mention of a relationship between Homelink buttons and the FEM in the FEM thread. Are they related? Had the right headlight stop working, bulb checks out OK, presume I have issue in FEM so will be pulling it for repair soon.
After a week or two, the left most button (which is the garage I keep the car in) started opening two doors (programmed to left & center button) again.
Anyone else experienced this?
Could it be a mechanical issue where the left button is actually catching both microswitches?
Didn't see any mention of a relationship between Homelink buttons and the FEM in the FEM thread. Are they related? Had the right headlight stop working, bulb checks out OK, presume I have issue in FEM so will be pulling it for repair soon.
This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.