Rear window installation in a 1963Thunderbird

[roy bakker]

I bought a disassembled project car a while back and I am installing the rear glass. Is there supposed to be anything to hold the glass up like locating blocks on the bottom?Since the rubber seal dosen't have a lip to pull over it seams something should be there to keep it from sliding down.

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[captrick]

Try googling rear window replacement on a 1963 T-Bird.....

 

[Towball78]

Not sure if you have installed your glass yet? It is held in by 1 long and 2 short metal strips fastened to the body with screws. I set the glass in place with the large metal strip to hold it up. Then pulled the rubber over the top and side seams. Once settled in place I fitted all the metal strips and tightened it down evenly.
I hope this helps.
Adrian