Rear window installation in a 1963Thunderbird | Ford Thunderbird club group 1955-2005 T-Bird models

Rear window installation in a 1963Thunderbird

  • Thread starter Thread starter roy bakker
  • Start date Start date
R

roy bakker

Click here to upgrade
Reaction score
0
Thunderbird Year
1963
I bought a disassembled project car a while back and I am installing the rear glass. Is there supposed to be anything to hold the glass up like locating blocks on the bottom?Since the rubber seal dosen't have a lip to pull over it seams something should be there to keep it from sliding down.

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 
Not sure if you have installed your glass yet? It is held in by 1 long and 2 short metal strips fastened to the body with screws. I set the glass in place with the large metal strip to hold it up. Then pulled the rubber over the top and side seams. Once settled in place I fitted all the metal strips and tightened it down evenly.
I hope this helps.
Adrian
 
You must log in or register to reply here.
Back
Top