57 Dashboard turn signal problem

[Clif57]

First of all, my dashboard turn signal lights work. The issue is: That while they are bright enough to see in the evening, I absolutely can’t see them during daylight. Is there a possibility that I could install LED’s as opposed to existing lights? Or what?

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[CSPIDY]

I’m sure there is an LED light for them but you will have to search the internet, there are many out there, good luck

 

[Clif57]

I’m sure there is an LED light for them but you will have to search the internet, there are many out there, good luck

Thanks for the suggestion. Will do.

 

[CSPIDY]

The LED lights are usually very acceptable to 6 or 12 volts, positive or negative ground. Like they don’t care. I’ve found them for my 28 model A. What a difference

 

[Clif57]

I’ve ordered some from CASCO. Let you know how they work out. Thanks for the feedback!

 

[Clif57]

I’ve ordered some from CASCO. Let you know how they work out. Thanks for the feedback!

Got the leds. Now, the problem is : How do I install them? The location of the dashboard turn signals lights seem impossible to reach. Any suggestions, if you do how about a step-by-step response? Hate to be a pest, but the designers didn’t seem to care about replacement.

 

[CSPIDY]

You have to reach up behind the dash, I replaced mine it’s a pain but they simply pull out. Take your time.

 

[Clif57]

Another good tip. Again, thanks for your feedback and in a timely manner. To me the operative word in your feedback is “pain”. Warm regards, Clif57.