2002 Upper Control Arm Driver's Side Rear Bolt

[350xfire]

Hey guys, I am dreading the re-installation of the driver side upper control arm due to the one bolt by the master cylinder. How have you guys tackled that one? I was ablw to remove it about a 100th of a turn a a time while cursing about 2300 times.... I really wish to not be this angry while assembling it...
Thanks

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[hemiguy]

Hi.
I feel your pain. I used an 18mm gear wrench. Still hard, but a bit easier.
Good luck!
John

John

 

[edward301]

I used a ratcheting wrench, only took minutes.

 

[lmc]

Oh, Edward 301, you have my car! First Whisper White I've seen on the site! So very nifty - NICE CAR!

 

[The Flash]

one of these. Think harbor freight. but you have to buy the whole set. they make them that the open end ratches too

 

[350xfire]

OK, I do have some but I didn't seem to be able to use it there. I will try again.
Thanks

 

[350xfire]

Well.... heck, you guys were right again!!! It works. I could only get about 3 clicks back and forth but it was way better than a standard combo wrench.
Thanks