2002 taillight assembly removal | Ford Thunderbird club group 1955-2005 T-Bird models

2002 taillight assembly removal

  • Thread starter Thread starter Cooge
  • Start date Start date
C

Cooge

Bronze Member
Reaction score
2
Thunderbird Year
2002
I have removed the two nuts as shown in the manual, but assembly will not come out. Is there something I’m missing?IMG_2018.jpeg

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

Attachments

  • IMG_2013.jpeg
    IMG_2013.jpeg
    2.6 MB · Views: 24
When I removed the one on my 05, there was an alignment pin that was really tough to release. It just took some gentle persuasion and a few hard tugs to break it loose. I put a little lithium grease on the pin when I reinstalled the assembly. Be gentle.
 
Greetings GaryP, the yellowish piece is in the second picture. Can you tell me where the alignment pin is located? If on the outside edge, perhaps I can use a wooden wedge. Also spray some WD-40 in the area, if I know what area to spray.
cooge
 
Instead of WD40, (Penetrant, demoisturant, rust preventative) use silicone spray (lubricant and mild dielectric).
 
GaryP said:
When I removed the one on my 05, there was an alignment pin that was really tough to release. It just took some gentle persuasion and a few hard tugs to break it loose. I put a little lithium grease on the pin when I reinstalled the assembly. Be gentle.
Click to expand...
The alignment pin goes into the retaining clip on the upper inside of the taillight assembly. As you can see in the attached picture, there are two plastic barbs on the retaining clip that lock on to the alignment pin.

doug7740
1955 Thunderbird Blue

Clip.jpg
 
You must log in or register to reply here.
Back
Top