2002 Ignition switch not responding after dash replacement

[Ironhead]

I have just replaced the dashboard in the 2002 T-Bird. It was, and still is a major project. Now that the new dashboard is completely assembled, back in the car and reconnected to all electricals, there is no response at the ignition switch. The lights are on and are not responsive to the switch, the alarm system activates every time a door is opened. There is no signal from the OBDII, so there is no way to diagnose any problem. As a note, proper mechanical procedure was followed, even to the point of using the correct air bag simulator tools. It seems as if a system reboot or ignition key reprogram may be the solution, but I'm not sure. Does anyone have any experience with this.

Thanks in advance for any assistance.

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[Frankie the Fink]

When you say dashboard are you talking about the instrument (gauge) cluster?

 

[Ironhead]

When you say dashboard are you talking about the instrument (gauge) cluster ?

I removed the entire dashboard, refitted it with a new shell and reinstalled that. That required the removal and reinstallation of the instrument cluster.

 

[biddle]

Did you rule out the PATS (Perimeter Anti Theft System)

Post in thread '2002 anti-theft switch location'

Dec 30, 2022

The driver reset switch (C515) is behind the left door panel.



Fault code B1830 refers to a door unlock disarm switch circuit failure.



Use pinpoint test M3 to test the driver reset switch.

doug7740
1955 Thunderbird Blue

• doug7740

•