ISO 1960 vacuum line 2 way T manifold fitting

[tszalew]

I am installing power brakes on a 60 TBIrd that had NO power brakes. The 352 engine came with a vacuum fitting that only had one port. I noticed on the 1960 vacuum diagram picture that the 352 had a 2 port fitting where one line ran to the the power booster. I had looked high and low for where to purchase that fitting!... Does ANYONE know where I can find (purchase) that 2 way vacuum manifold vacuum fitting?....

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[Special Ed]

If you don’t find the fitting, can you just use a “T” fitting to split the line?

 

[tszalew]

If I can find a low profile fitting that I can put the 'T' on top of that would work.... With the fitting I have on the car now, a T would run into the distributor... so I was hoping to find the fitting on a 352 Bird that already had Power brakes.... arrrghhhh....
Frustrating ......

 

[mark costello]

I may have one on my parts car. Ill look tomorrow.

 

[tszalew]

Thank you Mark!...

 

[mark costello]

Thank you Mark!...

I think i have thr fitting you are looking for. its located next to the distrubutor

 

[mark costello]

Ok, I think I have what your looking for. The brass fitting in the manifold near the distributor, one line goes to the brake booster and the other goes down to or towards the fuel pump. I have a picture Ill try to post it