1957 automatic reverse clunking

[mayman]

Have an issue with my 56 T-bird on when I reverse it it has a clunking sound I don't if I put my brake on hard I bypasses that is there adjustment on that I have checked all my U-joints Transmissions good transmission mounts good we built the whole thing no leaks just can't figure that out when I get ready to put it in reverse or drive it clunks a little bit I don't put the brake down please advise

This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.

 

[Tom Alpers]

Have an issue with my 56 T-bird on when I reverse it it has a clunking sound I don't if I put my brake on hard I bypasses that is there adjustment on that I have checked all my U-joints Transmissions good transmission mounts good we built the whole thing no leaks just can't figure that out when I get ready to put it in reverse or drive it clunks a little bit I don't put the brake down please advise

What you are describing sounds more or less normal to me. These transmissions don't have as many pressure controls as newer ones do and sometimes will bang into gear.

 

[bmac1060]

Make sure the engine idle (after warm up) is correct, approximately 600rpm (in neutral).
To high and it will clunk/bang. And as Tom said, some degree of bang/clunk is normal.

 

[Old school gear head]

Could be the pinion backlash. Make sure the trans shift rod is perfectly adjusted along with the proper idle speed!

 

[Bruce Hardy]

Also isn't there a reverse band adjustment.And I could be wrong on that also.

 

[Old school gear head]

Good point about that reverse band, but I’m not sure I do know there’s an adjustment for the forward band but has to be carefully adjusted and torqued in inch pounds!! I know because I almost adjusted it in foot pounds and could have broken the aluminum fork!!! The manual I was following didn’t specify inch or foot it just said tighten to 25 if my memory serves me correctly!!