valhalla 4771
- Reaction score
- 5
- Thunderbird Year
- 1957
I have the wiring for the power seat switch going down through the driver door, through the chase at the door hinge, up through the hollow space just past the pillar, out through the access hole near the bolts for the cross braces (see photo) And I have the wiring from the power seat motors running along the floor and up to the left access hole and grommet just above the circuit breakers. The male switch wires will plug into the female motor wires. My question is once the sires are connected, where are they held in place? Are they clipped onto the little horizontal ledge that runs below the circuit breakers? I see there is a clip already attached. Do first I push any excess wiring back through those access holes?
This page contains affiliate links for which I may be compensated. As an eBay Partner, and Amazon Associate I may be compensated if you make a purchase at no cost to you.
